© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Happy New Year all ! I spend some time on this car over the holiday, and it's certainly 1 step forward, 200 steps back.... First I broke another...
[ATTACH] This engine is not the easiest to get the belts on and cams lined up. On my 308 there are two belts which is much easier. I found...
Thank you all the responses. My conclusion is that I did it right the first time ! I went with 78 inch pounds which is 9 Nm. And then I...
[ATTACH] [ATTACH] Hi. Thank you for the replies. I did replace the inner bearing ! When I pulled the front cover off, the inner roller...
So. Yesterday as you can see, I installed the front cover. New seal, new bearing, new o ring etc. The tensioner pad for the cam drive...
[ATTACH]
[ATTACH] Front cover….
[ATTACH] Hi. I have a question for you guys, but first here are 3 pictures….
I am very jealous of FSM348’s engine. This is how I want mine to look ! I plan on doing a bunch of stuff while the engine out. may I ask….if...
Hey Tom. Tbanks for the reply. I have the engine out. I am going to remove it from the frame, like Ernie does in this thread. my primary...
Thanks in advance.
Hi. I am in the market for an engine stand and cherry picker. Anyone know how heavy the engine is ? It looks like the car weighs around 1.5 ton...
[ATTACH] You can see here the AC still in the car. I strapped it with electrical wire for the initial disconnect, but then during jacking I...
[ATTACH] And just like that the engine came out …..
[ATTACH] As you can see, the throttle cable is held on with a little circlip. It is not clear to me how you would remove this with the plenum...
[ATTACH] I lowered the car to around 10 inches off the ground, to investigate the coolant and throttle connections at the front of the engine....
Hi Ian. Happy new year to you and all ! on my car, both sides of the wiring loom have the large 78(?) pin connector, a smaller white connector...
[ATTACH] You can see in this picture, the purple / black / copper meal that I interrupted when taking this apart. Stupid mice.
When I put my car in the air, I jacked it to around 14 inches. I wanted to have room to work underneath. however the steps I have not...
One of the biggest advantages of removing the tank, is the wiring cable from the cabin is now super easy to pull. I was a little worried about...