© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Superformance item number 100343 has a 12 mm x 1.5 thread. I know this because I ordered one for a 308 and they sent it without the adapter that...
It's pretty well centered in the gate for 2nd and 3rd gear- equal distance from the end of the gate. I just put the engine in the car not too...
The car is running fine after the gas hydrolock situation. I don't think I bent anything, and I'm certainly not going to take the engine apart....
Adrian, Thanks! The wheels are the original Dino 14 inch rims. The tires are brand new.
alhbln, How much would the replacement circuit board cost? Steve
Three 308 gt4 questions: a.) I have brand new tires but there's a shimmy at 75 mph and faster, it was present with the old tires too- I thought...
Thanks for your responses....well most of them anyway. In response to the last post : no Falken does not sell a 205 70 14 in the US with an H...
Frustration. I had the Nankang tires installed on my rims - I brought the shop the wheels only- and the adhesive weights I requested interfere...
The other thing: to my eye the XWX looks too tall and balloon like: in this size its diameter is 26.8 inches versus 25.3 for the 205/70 14 tire,...
1 (one) Michelin XWX - 205VR14: $450 1 (one) Vredestein Sprint Classics 205/70/VR14 tires: $275 4 (four) Nankang Cx668 205/70/HR14: $218!
I hate to be the bearer of bad news: Sumitomo no longer makes any H rated tires that would fit our rims. In fact, I can't find any 225 60 14 or...
Correction: They don't make a 205 or 225 with any aspect ratio in a 14 inch size.
Fulda no longer makes tires for 14 inch rims. It's not even an option on their web page.
I have a "driver" 308 gt4 that is finally running pretty well after a 6 year ordeal of having the engine rebuilt and problems with the...
Anyone in Southern California have experience with this shop for machine work? I talked to them and they seemed pretty reasonable, but I wanted...
Anybody from Southern California out there? Someone must have some experience with machine shops out here.....
Thanks for the suggestion, but I was really hoping to find a local shop...SLO is about 200 miles from Pasadena, I'd like to find something closer...
I'm not going to leave it like this of course- there's 40 % leakdown on this cylinder....I think I'm going have it bored out to 81.5 mm and go...
I just measured the damage tonight. It didn't measure out as bad as I thought it would. The 4 cylinders on this bank are almost exactly 81 mm-...
You could be right about the water, maybe it had a blown head gasket in the past. Any other ideas about a machinist? The last time a rebuilt...