© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Most Ferrari owner manuals recommend checking the oil level with a warm engine at idle. Is this the procedure you followed? If so and the level...
I also saw this on FB. The former owner confirmed that it was a 209 engine with 77 mm pistons.
This is a function of the driving mode setting.
I would make my decision based upon the thickness of the disks. If they are less than the factory value for minimum thickness, they should be...
Correct. On all the new cars there aren’t any spark plug wires. They have been replaced with individual coils which are triggered by the engine...
In Ferrari parts books you frequently see destro for right and sinistro for left.
Actually, here is the inductive probe that is designed to work with a multimeter:...
Any zinc plated part can be given a yellow finish by dipping in a chromate solution. This is a DYI project. A chromate solution can be purchased...
As a general rule of thumb, it's best to hook up a battery charger/tender before disconnecting the battery to keep any computer chips powered-up....
I don’t have any experience with this car, but I would expect there would be an adjusting screw that acts as a stop for the headlight housing in...
On my 330 GTC vitntage V-12 I have 2 systems. At idle with the throttles almost closed, there is a vacuum system to route the vapors into the...
For cars delivered in the USA, Ferrari made a chrome frame to fit around the rectangular USA rear license plate and included holes and brackets to...
There’s no good place for a front license plate. The factory bracket is OK, but not great. I never installed my front plate; It hasn’t been a...
The top of the gear puller in your photo is common for many non-Ferrari tools. The thing you need to consider is whether there are any special...
You should read the description in the My Ferrari Connect link given above. Decide how much real-time personal infomation you want to share with...
I would check with your dealer to see if it is part of their warranty program. If not, remove it.
Loose bolts? Cracked weld in the seat frame? These type of noises are always hard to pinpoint.
I don’t know this specific car. However, would it be smarter to adapt the mating part to the existing stud configuration?
When water, usually in the form of condensation, mixes with oil you get that milky substance. It often appears at the top of the dip stick. As...
The Veglia analog fuel gauge has internal compensation for changes in battery voltage. See the attached photo. I suggest you remove the gauge and...
