© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Success!! It wasn't too hard to reassembled the master cylinder and I used a bench blender kit from Amazon to bleed. Lots of brake fluid spilled...
Rebuild rubber and bench bleeding kit coming tomorrow so hopefully I'll get everything reassembled by the weekend and report back.
@turbo-joe do you think I'm wasting my time to rebuild it then? The amount of rust in that area certainly seemed like it could leaking...
Yes that's just a reflection from lights in my garage. I'm thinking the cylinder was losing pressure though the rusty areas between the seals and...
I finally got around to removing the master cylinder and disassembling it. It was easy to remove thanks to a 13mm swivel socket I had "in stock"...
I went for a longer drive today and its still happening... I need to recheck the bleeders again with wheels off but I'm starting to think its the...
It was a leak after all... It turns out one of the inside facing bleeders on the left front caliper was leaking so I re-bled both front calipers...
Doh, my bad, I got confused when you mentioned TR thinking you were referring to the 512TR. I'm still new to this forum o_O
@lagunacc here is a photo of the ABS module in my car... it definitely exists and works [ATTACH]
Pads are fine, when I pump it again the car stops just fine and yes, if I apply enough pressure ABS will engage. I'm going to try to bleed one...
@turbo-joe I haven't found any leaks (and fluid reservoir hasn't seemed to have gone down at all) but will check carefully again before I bleed.
Good call @Drew Altemara ... just ordered another can of fluid. I'll give it a try over the weekend and report back.
One additional detail I forgot to mention, my TR also has the ABS module ... I did the second bleed with the key on (as suggested in another...
Hey, I installed new front pads in my '93 TR after I noticed they were almost gone while doing the suspension rebuild. I bled the brakes after...
I just had mine rebuilt at Performance Shocks, I live in Oakland so I dropped them off and picked them up... approx $3800 for all 6. Another...
Yes, @dontilgon , it was easy. The instructions warn you to test the plug to ensure power is setup correctly so I used a voltmeter to verify then...
@JIMBO that what I was trying to highlight with the photo -- original headlight on the left, Holley on the right. Holley is noticeably brighter...
Received the Holley 3000k "classic white" aka mimic old school halogen lights to replace my low beams. Installation was very easy however one of...
I got back my wishbones from the machine shop (Norman Racing Group in Berkeley, CA) with new bushings pressed in... they charged me $500 to press...
I just ordered a pair of these Holly RetroBright LEDs for my low beams. Their site said they should fit and bonus they are yellow 3000k color to...