© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Thanks everyone. I will check this out and let you know. H
It's a 1978 GTB. The frog eyes will not raise when I turn the headlight on. Funny thing is that the LIGHTS ACTUALLY TURN ON, but they do not...
Glad to hear I am not the only one with a weird and unknown camshaft. Not sure why your three other cams are all different numbers. You'd expect...
Why would a camshaft appear to have the part number ground off ? This is an intake cam. Blue color added to the grind. Not really visible in...
Aaaah. Thanks Rifledriver. A rotor from a V12 makes sense because the electrodes are indeed A LOT narrower than the one posted earlier. This...
Allright, finally back to answer questions. This is a single distributor system. This is a magnetic (no points) pickup system inside this...
I finally took a peek inside the ditributor. 1978 GTB (Euro). The rotor is held in place with a bolt and a wire. Can't say that I ever saw this...
Thanks a lot everyone ! This gives me what I need to proceed. Regarding degreeing my cam, I somehow need to figure out what cam I have, in...
Steve: So, this means you are NOT using a drive tool, and you are indeed installing the cam seals before bolting everything down, including the...
Yet another 308 camshaft question. I have literally spent days reading many very good threads about 308 cams, cam timing and degreeing, etc. Lots...
Thanks for great feedback Artvonne ! Not sure that my inner bearing dimension is different because of a later revision, or because I have a...
The 6201 bearing is 12x32x10 mm. I will keep searching for one that is "open" without seals. Seems too risky to use a sealed bearing without the...
1978 308 GTB engine. Replacing two bearings for the cam drive shafts. These are the two shafts that drive the cam belts from the engine, and these...
Thanks again for all replies. All of your input is very helpful. (ha ha, you're right. I went back to read what I wrote in a hurry and my...
Allright. Thanks for replies. The details: I actually measured the slop before removing the flange and the cover that holds the seal and...
This is a Euro GTB. I do not know if the differential is different on this car than the US specification. According to what the manual describes,...
1978 308 GTB. The drive shafts are removed for other reasons, but I did a quick tug on the output flanges at the differential and it shows some...
Great David. Thank you so much ! Hammerson
This spring I was replacing timing belts, and found bearings that were worn out on the timing shafts. Engine had to come out, and the timing...
Thanks Dan. I do have the right tool, and the staked areas are tapped back. I will try again. (If not, I may actually cut it too.) H