© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Does anyone know which ECU needs to be configured and how to tell a 458 that it does not have a seat heating (or has a racing seat without...
If you do the pump activation in this way, how do you make sure you do not exceed the maximum pressure ? Pumping until the overpressure valve...
Hello Charles, nice to hear that you found a solution for your problem. As you may remember from our conversation in 2019 i had a similar issue....
There are many possibilities. Wiring to the brake light switch or to the ABS module broken, contact not locked in the connector (so it moves back...
The brake light switch has 4 pins. Pin 3 and 4 should have battery voltage once Ignition is on. If the brake light switch is not ativated then pin...
Looks like there are some very bad solder joints on the backside. If the black areas are no burn marks and the traces are not damaged i bet the...
The ABS ECU is on the right side of your car. If you have removed the complete carpet which covers the brake fluid reservoir (as you see on the...
Failurecode "21" at your ABS indicates 'Main valve' failure. The valves are located in the metal 'block' with the "ATE" sign below your brake...
1995 355 usually means Motronic M2.7 and this do not have OBD which can be read by a standard OBD scanner. They are using a Ferrari specific protocol.
Thanks for the feedback. I know that the errorcode 1121 is always there when the engine is not running. But i was looking for the 4123 errorcode...
In the right hand side motronic ECU of my M2.7 F355 the failurecode '4123' is stored which means "Speedometer signal". The speedometer itself...
Due to a syncro failure we disassembled the (manual) gearbox of my 355 during the major service and changed the defective syncros, most of the...
We removed the covers on my 355 engine by using a screw driver. Put it between the cover and the head but be carefull not to damage the aluminium....
Thanks for the hint. I only did a search in the TR section before. The thread shows pictures from the cracked housing parts. Do you also have...
Does anyone have a picture of a broken TR diff and maybe also a picture of the "better" 512TR/M diff ? Would like to see some pictures before my...
A broken headlight switch (if it is the combo switch at the steering wheel) often means that a small plastic part inside this switch has cracked....
On the Teves ABS system you get out the codes as described in the manual. No SD1/SD2 necessary. But as No Doubt wrote you will have to remove the...
During the major service on my '95 F355 we found out that at least one syncronizer ring (2nd gear) is broken. This means we will have to...
At my headers i found some 'hot spots' on the shielding (see circled area in the picture). Since we removed the engine because of some trouble i...
It's not unlikely that the sender unit is bad again. I had this problem some years ago with the TR (same sender unit as 328 if i remember...