© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Effectively, yes. I get a drop now and then. It's hard to make a good seal.
Yes. Only 4 pins are used. BTW. I guess engine oil becomes an insulator creating a poor connection.
Over the past few months, the starter on my 86 US 328 would fail to engage on multiple occasions. The issue was predominantly during cold starts....
45K mi They did not leak before the rebuild. Maybe I didn't need to rebuild. But it made sense since the other suspension components were new.
Don't remember. But you can search my posts.
Yes. All four. The rear left seems to leak more than the rear right. The front are fine. This is most annoying because I don't have many miles...
The brake calipers piston seals are dry: [ATTACH] After drying everything up and going for a short drive drive, the shocks are leaking. Fluid...
I have not noticed the brake fluid level in the master cylinder reservoir being down significantly. But will monitor from now on. Will dry...
Yes. The rear brake calipers were just rebuilt. Along with the entire suspension ...
It's not gear oil because it doesn't smell. Maybe. This fluid is odorless. But the brake calipers are dry. This one is a puzzle. [ATTACH] The...
I did just have the CV boot/joints serviced. The leak is not coming from the transaxle side. It's coming from the hub carrier flange from the...
[ATTACH] I have to wipe this off very time I return from a drive. What is this clear stuff oozing between the CV and the hub carrier flange?...
Thanks Tim. No gearbox oil came out because I raised the car on the right side only and the left side was still on the ground. Update:...
Thank you Steve. If replacing the sender unit is needed, do I have to drain the transmission?
After bouncing speedometer needle behavior, it quit working altogether. Also not working is the odometer. Will have to follow troubleshooting...
Where do you get them?
Steve, Why does the dipstick tube need to be removed to change the engine sump gasket on a 328 engine?
It's my understanding that ride height is controlled by the loaded spring length. When I rebuilt my suspension on the 328, I had accidentally...
Front camber degrees as a function of mm shims is not exactly linear. Any thoughts? Notes: Loaded suspension on a level ground. [ATTACH]
What DOT fluid type is recommended?