© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I have it in my head that you can see the mark on one cam through the oil fill on the rear bank (if you remove the cap). I could be wrong. Good...
From what I can tell looking at pictures on google, the setup for 79 has a finned heat sink attached to the coil and the resistor. Do you have an...
If I'm not mistaken you have to swap both the HT leads (talking the single lead going from the coil to the distributor) and the low voltage...
You can try swapping the coils between banks and see if it follows the coil. Good luck. -David
Awesome machine, thanks for posting. One small, interesting detail. If I’m not mistaken it’s running 4 of the stock wheel bolts and the fifth...
Brembo used to have these dimensions online. I suspect they no longer publish them (as far as I can find) because they don't make these rotors...
Measured from the brake "hat" surface on my 75 308 gt4: Rear: 8mm Front: 19mm not including the dust cap. Including the dust cap it's somewhere...
In post 1869 am I seeing something that looks like a big red power cable wedged between the shock and stainless braided hose? I'm probably...
I had a similar problem on my 308 (clicking when going from a stop). The 6 bolts fastening the CV joint to the transaxle output flange (or the...
Maybe I'm misunderstanding your statement, but just in case... The hose that connects to the intake manifold (just below the carb) should go to...
Awesome news. Mark is correct, older data is on the left of the display usually. I’ve used some tektronix scopes from around that era and they...
I thought for sure that was it. Stepping back a little, going to when it originally stopped working… did it fail while running and never restart...
Without being familiar with VR sensors or the electromotive system, my first guess here would be we are not meeting a minimum voltage requirement....
Mark, with the VR sensor unplugged you are correct that it is 100% fine to ground one leg. It’s probably also fine when it’s plugged in but I’m...
One more thing… I think I would probably put the ground lead of your scope probe on the block or chassis. Connecting the probe ground lead to one...
Somewhere on the scope you will see “trigger” options. “Auto” means the scope continuously acquires and displays waveforms. “Normal” means that...
If I understand the website correctly, I believe you have a variable reluctance sensor. I’ve only used a Hall effect sensor, so I’m not going off...
I've never used an Electromotive system, but here are a few questions/comments that are hopefully helpful: 1. Is this a new install that has yet...
At risk of adding to the noise factor... if a valve shim got flipped out would a cam acting on an un-shimmed bucket cause a knock? I can't say...
"Freedom Overspill" https://vimeo.com/72196271
