© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Yep, I would use the AN16. I did have one of the lines built by a hydraulic shop and it works fine (and was fairly cheap) but it was a bit of a...
I would use these and convert to AN: https://www.pegasusautoracing.com/productselection.asp?Product=1219
Ah, those are DIN hydraulic fittings. See here: https://www.ferrarichat.com/forum/threads/oil-line-replacement-alternative.496578/
I have a set of challenge brakes with custom rear hats to allow the ebrake to work. So if there is a two piece rotor with e-brake provision, you...
As I understand it, battery reset procedure is to hit (enable) stop button on climate control, turn on battery, start car and let idle for 10...
Gave it the first real attempt to fire up last night. After cleaning all the jets and draining the bowls, flipped the fuel pumps on and it filled...
Per most of the reviewers, the sound is good in the car so a non issue if you own it vs. watching somebody else drive the car. It also sounds...
Except what makes the f80 so compelling is that it is a really good road car. Every review I've watched so far commends it for being a truly...
Yep, I will probably pull the plugs on that side and spin it over to clear any fuel from the cylinders before trying to fire it. It didn't run...
The Valkyrie is borderline unusable as a road car, and borderline might be too kind. I'm not in the market for any of them but I was really...
Weren't they all within a second? That would make it very track and driver dependent Looking at Harris's (and Ben Collins) review, the fact it...
Good news, fuel pumps and all lines to the carbs are fine, it's the crossover that's the issue. I stuck a fuel jug in the trunk with a line...
As it's a carb car, none of the lines should be high pressure. If I bypass I'll go directly to the carbs from a fuel jug with a cheap clicky...
This thread has pictures: https://www.ferrarichat.com/forum/threads/how-to-remove-the-steering-rack-from-a-355.430060/
Gotcha, but usually they have both concave and convex blanks, must be they don't for the mags.
It would seem that if you have blanks large enough for the rears, the fronts will also be possible (as the entirety of the front will fit inside...
You're not able to make the spokes the edge of the billet piece instead of the barrel? It would seem as long as the total wheel fits within the...
I get it, and I would do that if I were confident the rest of the drivetrain was good, but before I start down that path I want to check that the...
Occasionally on my car (also a 2.7) I have to hold the key on start for a few seconds before the starter kicks in. No idea why, but usually only...
Got it - where would the blockage be, from the tanks to the bridge or from the bridge to the fuel filter?
