© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Qavion, there is a good thread here about refilling the hydraulic reservoir. Not the big thread about removing and bleeding the hydraulics. I will...
Thank you all for your thoughts. Qavion I will have another look today, about the windows going down etc. Yesterday what I did was started with...
I have thought about it. The top has always worked pretty well (I had to do the center bar push up routine)-but otherwise worked pretty well. I...
Ok, thank you both for your responses. The top did not rise normally with the switch in the center console I have used for years-but if I recall,...
The roof was in the down position and would not rise from that position. When I used the emergency switch, it did rise and close. As nothing had...
No. The roof has always worked well. With no alignment issues. The shop that did the hydraulic replacement bled the system. At the end of last...
Hi, hoping Watson can chime in on a problem I’m having that seems related to this post. Last autumn my spider roof was not going up properly. I...
Wanted to update. Turned out that two of three ECU wires that connect to the crankshaft position sensor had serious damage. One was almost...
Great luck with the sale Mike, the car looks amazing, and beautifully maintained. I’ve sold two or three cars (I helped a neighbor sell one) on...
Thank you for the ideas. I will try them. Yeah, I’ve been hesitant to cut the wire coming from the ECU.
Thank you Qavion. I will think. For now, I will pull the three pins from the female connector we are talking about, and see if I can see any...
Yes. The car has the new crank position sensor from Ricambi, installed earlier this week, and I made sure the gap on that was correct. In the...
Yes. Today, I carefully peeled back the rubber boot and looked at wires, and the three pins of the connector. I can not see that any of the three...
Thank you, you, you guys, have made my day.
Thank you all for your ideas. Sincerely appreciated. I would be sunk if not for you guys. johnk, yelcab, qavion, thank you. I will play with the...
Update: Normally the cables circled in red and yellow below are locked in place with a metal contraption(photo below). Securing them in this way...
No, I think the four beeps happened, and then I rechecked the various trunks and doors, and now is the usual one beep, two beep sequence. I will...
Fuel level is half full. No I did not check the distance between the sensor and the teeth. The reading I had done last week, it said to be careful...
Hmmm. Now the car won’t start at all. It cranks like a champ. But no ignition. Alarm system seems to be working normally. ODB shows no codes.
Update: I replaced the TPS and nothing changed, after warm up, the car would stall at 2000 or so revs, with SDL/CEL coming on. I could barely limp...