© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Thanks for the responses and accumulator information. In 14 years there has been an adult in the back seat exactly twice. Both said once was...
My car is 1999 456M GT, 6 speed. I have owned the car since 2009 and have 80,000 miles. There is much to enjoy about this car but I am tired of...
I got it. Thanks to Graham. These are valuable pieces of information and deserve to remain available.
That is exactly what I want but the link to buy is dead.
I am searching for a colored wiring diagram a 308 GT4. All of the links I have checked are dead. Is the diagram available. Thanks.
I have GT4, 10848, manufactured May 1975. It has 2 coils and 2 distributors, one for each side of the engine. I also had an 84 GTS that I...
The exterior latch on the driver side is not working correctly. Seldom will the door open with a single pull. It requires multiple pulls to open...
Pirelli Cinturato P7's are on my GT4. Wear, grip and ride all good. Keith
Pistons are coming from JE Pistons. I do not have the specs but will get details.
Here are the heads from my 308GT4 waiting for pistons to arrive so all can go back together. I am getting excited, looking forward to a great...
I mistakenly flipped the pictures between the speedo and tach. Correct version is attached.
There is a lot of discussion in previous post by others. Search and you will find lots of info, some contradictory. Generally, I followed two...
Finally finished the dash. LED bulbs installed, new wire and lube for the heater controls and new Momo steering wheel. I used the jack nuts to...
My car is 1999 456M, 6 speed, 73,000 miles, major service 2/2017, tension bearings and motor mounts upgraded to 575 models. I am in Phoenix, AZ....
Related issue. Working on my controls I broke one of the bolts that clasp the cable wire to the control lever. Trying to make sure the wire was...
I have owned a GT4 for 22 years and recently retired. The car has become a project and I would like to connect with other GT4 owners in the...
Thanks for the input I really appreciate your comments. I will post pictures when the project is complete. Keith [ATTACH]
John, The tabs are fine but most of the imbeded nuts are gone. In 2 cases it appears the fiberglass was tapped to accept the screw, 1 hole is...
Thanks for the suggestion. Unfortunately, the clips are not long enough, they will not reach from the edge to the hole. I have searched without...