© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Thanks for posting a link. The Kit includes "4 BALL JOINTS,8 A-ARM BUSHING AND 8 SHOCK BUSHINGS.". You should look at the photos to see the...
In case anyone needs a front end kit I listed mine new one on Ebay for $199. I bought it from Maseratisource for $695 a few years ago for my 308...
Since I sold my '81 GTSi last week I put some items on eBay. If anyone needs a front end kit I listed mine for $199. It was from Maseratisource...
Crowndog: I was actually talking about the wires that the sensor connects to. As far as I can tell the sesors and the wire attached to them are...
AndyWW: Do you know of a source for the wires? Thanks.
I tracked down an ignition miss to the wires that connect to one of the crank position sensors. I had to strip off the black outer insulation, and...
I have an '81 GTSi and this winter I plan to cut out the rust and weld in repair sheet metal. Can anyone recommend what repair sheet metal I...
How is $59 per tire not much less than $575 per tire for the xwx?
I found these on another site for $59 each, so yes they are very cheap tires. So were the sumitomo htr 200s, and I thought they were a great tire...
The manufacturer is mispelled in the item above. It should be Nankang. The tire rating shows 95H. It also says it fits a 6" wide wheel, and...
Anyone ever heard of these? Nankang CX-668 Tire 1 New Nanknang CX 668 Tire 205 70 14 205 70R14 2057014 95H | eBay They claim to be "H"...
The web site shows they come in 16 inch, but strangely none of the models come in the correct 5x108 lug pattern.
I have an '81 GTSi. Last year I noticed the front coil was cracked and sparking, so I replaced it with a new one of the same OEM type. The motor...
That is what I needed to know. I thought I heard something about a fuel cut off relay under the passenger floor board. Is that shown on the...
I meant the cold start injector. My 81 actually has two fast idle controls: the Auxiliary Air Valve and another vacuum controlled valve. I'm not...
If I understand what you are saying, a 308 GTSi with all the fast idle equipment removed and the cold start injector disconnected would run the...
Thanks, but I did all that two or three times. New wires and extensions too.
You say that there are eight curves. Is the vacuum sensor just an on/off switch, or does it give an analog signal indicating the exact amount of...
I have an '81 GTSi and I am thinking of installing a programmable ignition this winter. I have been reading all the relevent threads I can find...
I have a 2V-FI 81 GTSi with US configuration. Is the ignition curve controlled by the RPM sensor input, the vacuum input, or both? My...