© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Chris, The pic is a little confusing but... the flywheel and pressure plate w/ appropriate fasteners are needed. All the pieces to the right...
I just threw that out Mark. ;) But for a show it would be great - will also keep "things" from entering the intakes during a show. Does...
Mark, Make a mold of the air box top when finished and have one cast in lexan. Good filters are the best idea. Tom...
Wow! Tom...
Wonderful execution Mark. Looks like it is supposed to look. Tom...
Mark, You Are a master at welding... just a bit of fill in the dish, a gentle cut on the mill and voila! the correct chamber shape on the...
Sorry about double checking your math Mark. My bad. I've been focusing on my math (valve guide angles) and didn't catch yours. The adapter...
I know... I have 2 die grinders but my wrist is nowhere that accurate. Tom...
I knew that was coming but didn't want to say anything. Tom...
I totally understand. I have been doing just the same on my 50 year old heads. My problem is welding junk castings. Too much debris coming out,...
Mark, Have you thought about angling the intakes forward on the left head and rearward on the right? Or visa-versa. Maybe 5 to 8 deg....
So is this measurement being taken with a probe or being calculated? Tom...
Mark, I take it the velocity is being measured right in the center of the port(middle of the hole), not out near a side nor approaching the...
So the top and middle pieces you are cutting and pressing in a taper? I figured trying to squish this pipe would lead to cracking. The heat is...
I didn't see a type stamp on this tubing. 6061 T6 I presume. If so, are you heating them to kill the heat treat so they bend and squish easier?...
Thanks for the info. 1/8 to 3/16 should be plenty strong. Are you going to get this one on the flow bench today? Tom...
That does look really nice Mark. Did you "V" groove at each weld and did you weld on the inside seams? Looks like most, if not all of the...
Mark, What method will you use to attach the TB to the manifold? The original boot? Tom...
Mark, Are you sure you want to use aluminum bronze? I have two 3' rods of this I had bought for guides but did a little research and decided...
Mark, Is this board something I can use on my 6 cyl.? I will at least run the Hayabusa TB's. Might need to go to something bigger once I get...