© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I recently had a mishap with my 18" 5 spoke Speedline (SAC RS30), spline drive wheels, where one was severely bent- front. I had it fixed but it...
Does any one have a good source for inexpensive windshields for a 348 or 355 in California or specifically Los Angeles area? Or something that...
After a few months we finally got it. We built a tool. When I say it fought until the last millimeter, I mean it! Bent a few thick metal plates...
I built a head puller as was suggested. Pushing off of the transmission and middle engine hump. At this point when I tighten the 1/2 inch bolts,...
Trainman, looks like it is probably what Moorespeed used. Only, I'm not sure that design will work with a TR because there is nothing to push off...
I would be interested in 'Renting' it from him if possible. Is he in TX?
Steve, I would love to see what Moorespeed built. Most are great ideas on here, but 1. the head gasket has blown the seals(probably fractions of...
I have tried(heat hammer) both but to levels that I thought were safe. I guess it might be time to go to extremes. It's a big head so it is hard...
If you look at the second photo you will see that the studs are kind of hidden beneath part of the head. You actually have to have a special tool...
I'm hoping someone can help me- as I need it! We pulled a 87' Testarossa engine a few months back because it had a few bent valves from a slight...