© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Check out 901-211-195-01-M260 at Pelican Parts if you don't mind a Porsche part :-)
PM me - I have drawn one and it's free
Sadly the last Ferrari hose I purchased was $200 - many years ago - and it wasn't a very long hose. Nothing special about Ferrari hoses - purchase...
After I lowered my '83 QV I was upset that my scissors lift would no longer slide under. I bought these FlatStoppers® from Race Ramps and fixed...
Yes Tia - remove the lights to get the panel out. When putting the panel back I put a piece of string on each socket and thread through the...
I just remember being very confused while reassembling my 308. It is very difficult to tell which is which from the pictures. Better off to mark...
Hello Dave I'm 6'4" and I did it. People don't understand what another 3/8 to 3/4 inch can do to help tall guys. I also added an eccentric...
Many cast parts of the motor have casting marks/dates on them
I will gladly post once it works. It will make an odd paper weight as Verell would say :-)
It's made from available 1.5" x 1.5" x 0.188" steel angle It requires a threaded hole which is the main reason that I will not consider aluminum.
It's for the stock seat due to my height and I don't tell them what it's for. Thanks for the response!
Does anyone know of a good machine shop that will do a small one-off job? I have a design for some bolt-to-the floor driver seat brackets that I...
Yes - the solenoid is removed as part of my engine beautification project:-) Just be sure the plug the vacuum line going to it. Art
You must plug the holes in the large hoses - this device is an air bypass and when you remove it, outside unfiltered air enters into the circuit....
TacElf and myself have developed a prototype solution for the antiquated OP sender in the 308/328. It consists of three elements: 1. A modern,...
The heater blower replacements from Superformance are similar but not identical to the OEM SPALS in my '83 308. They lack the Ferrari mounting...
I'm looking at one of these to help with gauge visibility as it raises the wheel ~12mm. I am aware that it also sets the steering wheel ~16mm...
Hello TacElf, I'm working on the same project, albeit slowly. I was looking at using a PIC chip. A:D input - lookup table inside - D:A output...
I am working on a project to possibly make the 308 oil pressure gauge accurate. The missing piece of information is the mechanical thread sizes...