© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
replace the engine can solve the problem
You can exchange EV4 to EV3 or EV5 to test.EV4 is use for select the gear from 3,4 to 5,6 gear.
F1 system is not complicated.I am not work in your car so is difficult to indentify what problem. I think only dealer can help you because...
Dont exchange the solesonid valve both side of power unit,there is two type of valve.one is for engage ,another is for selection.SV1 & SV2 is...
The vehicle with 79K km.I suggest you check the three bleeding screw at the actautor,if loose,will cause pressure drop down.Besides,use the...
Yes,the battery can recharge.Charge it about 24 hours and then check it again.
I think your car is F430.Some problem in the TPMS in F430.Can not calibrate easily.You must go to the dealer to fix it.
I have few expenrience about that.After drive a long time,the clutch disc and flywheel have little bit deform so you shift to R but the primary...
Why replace the sensor and thrust bearing before?
After drive your car a long time??At hot or cold engine temperature??
You can press the TPMS Cal button when key on .Then drive your car about 15min.to calibrate the TPMS.If "no cal"still on at dashboard,maybe...
If you check all parameter is ok,may be failure of the new clutch sensor ,the bearing fix not correctly or F1 ECU problem.
Sorry,if use in the other F430,need recode the key use SD3.
If you never change the transponder inside the F430 key house,no need to recode th key.
What year of your 612 and the warning on dashboard is 'pressure too low' or 'TPMS not cal'.??The pressure value show correctly on dashboard or not??
i have experience to install V1 radar in F430.I put the radar nearest to the rear mirror of the front windscreen and then remove the sunvisor &...
I want to know that your car is F430 or F360,can you take the photo about the damage key and blank new key,the key use in F430 have remote control...
I think item 16 in the diagram is broken,it can be replaced. [ATTACH]
May be engine problem cause high temperature at the catalytic convertor,failure of the catalytic convertor ECU or the earth of catalytic convertor...
Yes,it is possible.