© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I started to rebuild the front calipers on my '79. As I was watching a video of what was supposed to be a rebuid of a Porsche 911 sc I realized...
Steve Thanks again, I found a schematic for the relay to identify the functions of pins 1 and 50 for my own understanding of how the relay works....
Brian my issue is about needing accessory power when the engine is not on and I need to test stuff that requires me to be out of the car. The...
I have a 79 308gtsi it was the last year for carbs and dists in the 308. I am running the original ignition. More specifically I was trying to...
Years ago, I bypassed the seat switch for the fuel pump.I know this is old stuff but as I am installingf an XM radio I have had the ignition sw in...
Did you check the plugs? Could they be fouled? What's with the starter motor is the engine cranking now?
Discounttiredirect just called to tell me they didn't have them in stock either. I went for 4 Bridgestone S-02A's. Your right about the peace of...
Thank you all. I found and ordered The tires on directdiscounttires.com. I did order both rear tires as suggested. I also agree that the bubble...
I have a 2002 360 with 7,000 miles. One of my rear tires, a Pzero 275/40 zr18 has a bubble in the side wall. Does anybody know where I might find...
If you still don't have the spec you are looking for I took these pictures thinking you wanted the height of the fly wheel. If you wanted some...
I don't know if you'ld call it rust, but on two separate occasions after I've had the car in storage, the clutch became "glued" to the flywheel. I...
Thanks for the suggestions. Since the dizzy was off I decided to pull the cover, I was hesitant about trying to drill the seal and am not sorry...
I haven't tried. This all looks very tight to me and I'm not sure what to try removing first. The center ring on the cam and the steel outer ring...
Removing the ring bolt was very straight foward. I used the special socket and an adjustable open end on the other end to secure the cam. Looking...
The tools the thing, Thanks Steve. I'll wait on the socket, I didn't have much luck trying to make my own. It was an oversight on my part, but...
I'll try the strapwrench first, if I can't secure it I'll take it from the other end and do the timing belts at the same time. My concern about...
Can you tell me what you would use to remove the nut holding the pully on the shaft, and how you hold the camshaft? Thanks
Timing belts are on my list along with an xdi/dis conversion. I can probably do them all at once if I have to. Thanks for your help.
I have a small leak from around the cam seal behind the heat pump pully. I would appreciate any help or tips that might guide me in replacing the...
The dealer does not own the car and from what you are saying he doesn't want to. You must ultimately deal with the leasing co, they own the car....
