© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Thanks... Just an update. I happened on a box of parts that came with the car when I purchased it from the last owner and the box happened to...
Hello Everyone, I searched our website regarding the type of spark plug wire, wires ohm value, type of spark plugs used, red or black spark plug...
If you read my previous threads you can see I have been chasing my tail on a phantom oil leak. I have had my bell housing off three times and I...
Hello I would like to borrow a Baum Ferrari Clutch and Transmission Groove Nut Socket 45mm. I will pay shipping both ways. thanks
Hello everyone I am looking to borrow a 22mm box wrench. I am working on my 1977 308 and have to torque the two lock nuts on the shaft ends. I...
I replaced my rear main seal and drove it less than a hundred miles and it started to leak again. What did I do wrong and does the new seal need...
I dont know if you got your answer already but try this. There is a small hole in the bottom of the bell housing just above the clutch lever....
I know when I have been hog tied. Sorry for placing you (Bigtex) in the same catagory as a time waister. My fault. You obviously have some great...
What I really like about the internet is that it offers a lot of useful information that I can learn from. The few problems I have about the...
The solution was easier than thought but gets lost when adjusting the clutch cable to satisfy the 6mm "misalignment". Turnbuckle #4 adjusts the...
It was both the rear main was leaking and the three "O" rings. So the car was leaking a lot of both fluids (but what made the diagnoses confusing...
After a little fiddling I found out what the trick is. If your any one than BIG TEX (lame comments and no help) I will let you in on the fix.
I did find out what it took to make the adjustment. If your any one but RIFLEDRIVER (what a time waister) I will let you know the trick.
I dont belive you even own a FERRARI
well your a time waster
I have the manual and Ferrarichat and followed everything according to instruction. I believe the old clutch had soooo much adjustment for wear...
Its a 1977 308GTB. This is the free play type of clutch (the throw out bearing needs the 2mm clearance). The clutch pedal does have a stop and...
Sorry, I have a 1977 308GTB
I have an excessive amount of free travel of clutch pedal since I installed my new clutch. I can not find any info in my mech book or owners...