© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
When I took apart my 328 water pump, thermostat there was this jelly like material. I assumed it was because someone had either let the coolant...
I will try to take some pics this weekend. I need to remove the plastic spare tire shrouds and see what is under there.
Has anyone had their crank pulley rebuilt? Mine looks kind of crusty and have no idea if there is rubber inside of it or if it is even possible to...
I am bad with time. I have been so busy with work but I have started working on the car again. derekw, I am working towards exactly what you...
I finally got the pulley off! I tried the heat inductor, propane, PB Blaster for days. This thing wouldn't budge. I was finally able to get a two...
That looks different than the 328. I will upload a photo of what I have. I took a bunch of photos of it. I wonder how much a metal shop would...
I just bought one for a 328. I am guessing it is the same. I haven’t installed it yet. I could take pictures of it.
Thanks for the input, I just bit the bullet and did it. I have a DeWalt electric wrench that made light work of the crank shaft pulley bolt so I...
Does anyone know what the torque value is for the lower drive pulley on a 328 is? I’m about to change them (hopefully tonight). I don’t feel safe...
The time just flies doesn't it. I finally tracked down all the parts I needed and a few extras. I got the cam locks from Verell and some other...
Does Ferrari care about the older cars? I am new to the Fcar world. The numbers of the cars are lower so I am guessing there isn't as much money...
I need to setup a plating station in the garage. How are people doing their crank pulleys? I was thinking to acid bath, zinc plate, then black...
I got the tool, thanks for the info! I have parts on order from the UK and USA. I am hoping to finish the belt change by the end of June...
Thanks everyone. I have a thread about it, I am about to start updating it. Parts are on the way and I am about to get to work on it. I will be...
Or does anyone know the size or a type that people are using for them?
I can't find those pan nuts, washers, and a crush washer on any of the parts diagrams. They are there, but they aren't clickable or listed. Am I...
My friend bought this in 2017 and I strongly advised him not to. He stashed it in my detached garage and I helped him start working on it as it...
I think I remember reading something about people doing a run of these targa tops for 911s on Rennlist. I think the company that was making them...
I ordered the kit and it should be here by the weekend. My seats are pretty dried out and dirty. Is there a write up that you followed that is...
Where do the seals go? I am looking at the parts diagram and don't see....