© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I have had a 365, rather than 330 GTC, but cannot think that what you have found is correct. The fuel line should be clipped along one of the...
I think there was probably just a bit of muck under there because once I got it moving it came off quite easily and has cleaned up fine. In the...
My cam belt service came to a dead stop when I couldn't pull the harmonic balancer off the front of the crankshaft. I had heard a few horror...
Oh, I managed to keep the ashtray and lighter set up, so you'd never know I'd done anything unless you are into the detail. I'm into cam belt...
Point and squirt versus a more sedate ride with the added advantage of decent aircon, but then I'm quite a bit older now! Both great cars. A...
This is the third Ferrari I have been fortunate to own over the last 20 years or so. I started the journey with an immaculate1989 328 GTB with a...
Funny how one thing leads to another.....
Well done, glad you got it working. What will you use to seal it back up?
Yes you are seeing the start/stop operation correctly and I'm afraid it is just old fashioned elbow grease and not a very nice job. I guess that...
Hi Jared, I missed your earlier post about removing the muffler but I see you've managed to take that out. I'm sure you'll do fine with the motor...
OKAY...I got the message, thanks for all the replies
Hi, My 456 is fitted with Pirelli P zero tyres, front and rear. The front tyres will need replacing soon and I have a good source for Bridgestone...
What a lovely hotel, my wife and I have stayed there twice. On our first trip some years ago we took our 365 GTC and parked more or less in...
So I used the epoxy compound to seal the gear case and motor and it has definitely done the job but in retrospect it probably sets too hard to be...
I think you might be on the right track with Plastidip. I have used it in the past but then ,managed to forget about it until your reminder (old...
I cleaned everything up and got rid of all the old grease in the gear case. I paid particular attention to the three internal terminals and their...
Hi Qavion, I'm not ignoring your questions but I will have to get back to you later. I decided to bite the bullet and take the unit apart...a...
So... I put 12 volt through the motor via M & V on rviani's diagram and the good news is that the motor turns freely. I have then traced the...
Thanks for all the comments and especially for the wiring diagram. I have seen several posts about this issue but somehow it's different when it...
Hi, I have a 1997 456GTA and the rear spoiler is not operating properly. During normal driving the spoiler warning light will flash for a few...
