© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
I don't remember any specific instructions, but I think you just cut the webs out. I used a sawsall, but you will need to be really careful with...
Well, nice warm day here in VA so I decide to take the old 348 to work. Coming back on the interstate with a semi in front and one to the side at...
Thanks guys. Daniel, if they have the Stant locally I may just pick one up tomorrow and order the other one later. I need to put together a list...
Gents, while checking fluids today the end of the expansion tank cap came off and fell into the tank. I pulled the coolant out and retrieved the...
Thanks. it may very well be the TO bearing. I will eventually get around to checking it out.
As of late I have noticed a strange kind of clickety type noise when I shut the 348 off with the clutch depressed. I also notice a small noise...
I have a Max Jax. It is awesome. I don't know how I did without one for most of my life! If you are like me and have a residential garage it is...
A couple more suggestions, make sure the connection where the rear brake lines attach to the car is solid and doesn't leak. If that connection is...
Every once in awhile my car does something similar. It doesn't idle right and when you hit the throttle it doesn't go for a few seconds....
Engine has to come out, not much chance of getting the crankshaft pulley off with the engine in the car. It isn't that hard to remove the engine...
The bubbles indicate gas state refrigerant before the expansion device. There should be only liquid refrigerant to the valve. Carefully add...
They just pop out of the door panel. A wrapped small flat screwdriver works fine. I was just very careful without the tape, no scratches.
Could be the wiring, however, mine has done that several times and has been the switch. It just takes a second to pop out the switches, spray...
Yep, that's it. The slave cylinder for the clutch is in the rear and if the seals start leaking they will deposit fluid underneath the clutch...
http://www.ferraridatabase.com/The_Downloads/The%20Documents/Workshop%20Manual%20348.pdf I don't know the torque right off, but the link above...
My bad, I was thinking of the bars leaks coolant product. The oil product is as you noted, it causes the seals to soften/swell. That being the...
I would not use that stuff on one of these engines with the dry sump set-up. That being said, the stuff is really for leaks past gaskets where it...
My car on occasion has the same problem, I noticed it on occasion shortly after I would wash the car/engine off. It did it again recently, I...
Get a lift, they are inexpensive compared to having the service done. I have the Danmar MaxJax which is portable. The proper way is to remove...
You know, seeing this thread just reminded me that I never did mount mine to anything. I mounted the driver's side items and just stuck the...