© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
You guys are too sweet. Gift baskets are in the mail...
Better safe than sorry. Split the case, pull the side cover and inspect everything. You will also want to flush the entire housing as much as...
Is your trigger finger itchy? lol
I personally have only come across this a couple times in various models. Not the sort of problem we advise people to be wary of. I'm sure there...
We would raise the car. I won't describe the process as I prefer not to potentially be linked with a major mishap due to "something some guy on...
If you had the ignition on while the cluster was out, the only way to clear the airbag light is with a diagnostic tool. You will need an SD2 or...
I have done engine outs on jack stands, it's as sketchy as sketchy could get. I recommend just pulling the motor up through the top as if it were...
It is NOT reverse or "left hand" thread. I've never had an axle nut give that much trouble, I'll be curious to hear how difficult it is to knock...
I LOVE sub 20k mi 355's, they're a gold mine. My favoritve conversation: "the car has always been perfect so I have never needed to do anything"....
No photo is displaying. Anywways, that nut is torqued to 200 ft. lbs. You will need a serious breaker bar or impact gun to loosen it.
With cars of this age, anything is possible. Unless you're driving on a really bad road, I doubt stiff shocks are causing the issue you're...
I haven't seen every car ever built, but the answer is most likely "yes". OBD2 wasn't instituted in the US officially until 1996.
I'm certain you will be pleased with the result. The drop in ride height looks great and the increased spring rate helps make the car feel more...
I'm not worried about it :) Are you keeping with original rubber bushings and Konis? Nice Tips, BTW!
The numbers can be manipulated and a casual check can be deceiving. You want a qualified tech to perform the SD readout in conjunction with a...
I've used two machine shops, one on the West Coast and one here on the East Coast, both been around long before I was. Both recommended the use of...
That could depend on just how "perfect" you are wanting it. I advise you to be prepared for a number around $10k for a complete end to end job.
Don't assume anything, it WILL cost you money you didn't intend to spend, in the long term. Valve stem seals are at the top of the valve...
If the engine is running properly, it will measure clean even without catalysts installed. The cars run fairly clean when tuned properly. If...
Matt, congrats on finally being able to get the 308 out for the refresh! I've heard good thinks abotu Sport Auto's work and expect you will report...