© 2025 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Hi My 2013 Cali 30 has a very light misfire (hesitation, stutter) which presents mostly during warmup. It's been intermittent and no fault codes...
Hi My Cali 30 is is driving fine and shifting all gears ok…BUT it’s throwing an active fault code for Even Clutch Speed too high. The code has...
Swap maf sensors and see if the fault swaps banks too
Mine was a Maf that failed, intermittent for a while until it failed properly and ran like half the engine had fallen out. I was reading fault...
I do hybrid maintenance, I pay for the most basic annual service at the main dealer and inevitably they give me a £12000 quote for work that needs...
I married an ex communist block accountant, if I can convince her two Ferraris is a good idea then you should have a walk in the park. Just make...
Mines the same.
Test drive competed and it looks like the Maf was the problem. Let’s see how the next few drive cycles go
The P2140 code hasn't returned (yet). I've only done 50 miles since the fault which has now transformed into a MAF failure. My new MAF arrived...
I thought I’d carry on the story, it might help someone in the future. The car ran ok on the last couple off runs last year before I put it away...
[ATTACH]
Have a beer or two to numb the pain and shove your hand in there, it’s not too tight
Hi My 2013 Cali 30 went into limp mode with engine light on and lots of other warnings, 150miles into a weekend away. It didn't reset on the key...
Did anyone get a solution to this? I’m in the same place myself!
So, battery left on a charger. Fault still present on code P2140 and won’t clear. Comes back immediately as an active fault
The car had been on a tender and was 100miles into a 150mile trip when it failed so I doubt it but I’ll give it a go :)
Hi All My 2013 Cali 30 threw all the error messages and went into limp mode today. Battery removal and fault code clearing made no difference and...
Glad it’s resolved without too much pain.
I'm always for starting with the simple stuff. Earth the body of the starter with a jump lead. Swap out the battery temporarily for a known good...
I had exactly the same issue but it was intermittent before total no start. The copper contact on the solenoid had arced and didn’t have a good...
