Proper placement of Scuderia Shields on 2000 360?

The factory fenders are indented to accept the factory shields.

I can give you measurements if we are looking at all the same measuring points.

 

Ok, but I'll have to do on Tuesday, 29th, because I left my camera at my office.

 

This is my 04 factory shields, hope this helps
Image Unavailable, Please Login

 

I would be interested in this as well. Can anyone take measurements for exact placement? Are the aftermarket shields nice enough or do they look cheap?

 

Ressurecting an old thread here, but did anyone ever get the proper measurements for the shields on the 360?

 

Sorry, I guess I did forget to do that. let me see what I can do.

The factory shield measures approximately 4" high by 3 1/4" wide.

These measurements were taken on the driver's side:

a) the distance from the vertical center of the shield and to the top of the crown on the shield to the cowl crease around the windshield is 6". That is, if you looked at the center of the shield and kept the center plumb vertical the top of the shield to the cowl line is 6".

b) Looking at the width of the shield and to the right point of the shield, the distance plumb horizontal from the right point of the shield is 3" from the door crease along that horizontal line.

c) The bottom point of the shield to the fender crease below is about 3/8".

I don't know what other measurements to take that could give you more than this.

BTW, my wife thought I was nuts going to the garage with a ruler at 10:30 PM !!!

 

Greg,

Thank you so much! Tell your wife "thanks" for me as well!

Jim.

 

Maybe she thought I did not "measure up"!

Hope they help and in conjunction with the photo posted it should help you.