'17 488 Spider Wheelspacers - Need some advice | FerrariChat
Buy

'17 488 Spider Wheelspacers - Need some advice

Discussion in '458 Italia/488/F8' started by spider17, Jan 11, 2025.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. spider17

    spider17 Rookie
    Rossa Subscribed

    Jan 3, 2025
    8
    Phoenix, AZ
    Full Name:
    Sasha
    #1 spider17, Jan 11, 2025
    Hey guys, i was searching the forum but didn't see any threads with Wheel Spacers and I would like to get some Help, Advice if possible wheel spacers.

    Anyone has any good sites where to get them from?

    Any specific Brand?

    Thank you in Advance!
     
  2. todd cloud

    todd cloud Formula 3

    Jun 21, 2019
    1,086
    Full Name:
    Todd
    #2 todd cloud, Jan 11, 2025
    A lack of response IS advice, no?
     
  3. RoadRonin

    RoadRonin Formula Junior
    Silver Subscribed

    May 18, 2020
    514
    San Francisco
    #3 RoadRonin, Jan 11, 2025
    Here’s info I shared about the spacers and extended Ti bolts I had installed on my F8.

    https://www.ferrarichat.com/forum/posts/148726266/

    Lots of useful information in this thread.

    I went with Capristo but Hill Engineering and Novitec are also good options.
     
    spider17 likes this.
  4. Rocco Rosso

    Rocco Rosso Rookie

    Jan 8, 2021
    1
    Full Name:
    Bill
    #4 Rocco Rosso, Jan 11, 2025
    My 2017 488 Spider with Novitec spacers, 10mm on the front and 15mm on the rear wheels.
     
    spider17 likes this.
  5. Marty305

    Marty305 Karting

    Dec 21, 2023
    109
    Full Name:
    Marty Sifuentes
    #5 Marty305, Jan 13, 2025
    I have 15/20 from SRM Autosports
     
    spider17 likes this.
  6. spider17

    spider17 Rookie
    Rossa Subscribed

    Jan 3, 2025
    8
    Phoenix, AZ
    Full Name:
    Sasha
    #6 spider17, Jan 13, 2025
    Thank you! That Helps!!
     
  7. mdrums

    mdrums F1 Rookie

    Jun 11, 2006
    3,447
    Tampa FL
    #7 mdrums, Jan 13, 2025
    Not a fan of spacers and the issues some spacers create. Wheels with proper offset is the best way to go. I don’t feel a stock 488 needs spacers until it’s lowered a lot such as on Novitec springs.

    However if you must, Hill Engineering are the best spacers, built to higher specs than others. You’ll need all new wheel bolts too as the oem bolts will be too short.
     
    RoyalPink likes this.

Share This Page