I searched forever trying to get my 2006 to sync up with my iPhone. I might have overlooked it, but I couldn't find one mention of bluetooth in the manual. The car had the send/end buttons but no sim card slot in the glovebox which is mentioned in the manual. So I figured the buttons were there for some reason. One day I did a blue tooth search from the phone and Ferrari 612 popped up. If your car is stock, with no sim card spot in the glovebox, then try searching for the car from your phone. Sent from my iPhone using FerrariChat
The car does have Bluetooth from FERRARI S.p.A.. Battery was replaced and connection was lost. Need the steps / sequence to reconnect. Factory code if I remember four numbers which I do remember.
Going off of memory, I believe the code is either 1234 or 0000. Most all of the BT codes from that time period were one of those two. Sent from my iPhone using FerrariChat
Steps: 1. Ignition on 2. Go to the blue tooth settings on the iPhone and let it search. 3. Select the car 4. Enter code. Either 1234 or 0000 When I first tried this, I got an error display in the Becker saying memory full or something along those lines. The car BT will only store a certain number of devices. To clear the memory, hold down the send/end buttons at the same time and wait for a notification that the memory has cleared. Ten to twenty seconds I believe. While I'm sure it exist somewhere, I've never come across the reset information anywhere. It was just some trial and error as well as some luck. Sent from my iPhone using FerrariChat
