308 Starter/Flywheel | FerrariChat
Buy

308 Starter/Flywheel

Discussion in 'Technical Q&A' started by FasterIsBetter, Jan 24, 2007.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. FasterIsBetter

    FasterIsBetter F1 Veteran

    Jul 22, 2004
    5,856
    NoNJ/Jupiter FL
    Full Name:
    Steve W.
    #1 FasterIsBetter, Jan 24, 2007
    I posted this question on the 308 forum but haven't gotten an answer. Someone must have an idea about this -- Do all 308s use the same starter/flywheel setup? I have the engine out of my '78 GTS and am thinking of swapping the starter for a high torque gear reduction unit. If there are variations in the starter/flywheel setup, when did they occur?

    Thanks,
    Steve
     
  2. Steve Magnusson

    Steve Magnusson Two Time F1 World Champ
    Lifetime Rossa

    Jan 11, 2001
    26,931
    30°30'40" N 97°35'41" W (Texas)
    Full Name:
    Steve Magnusson
    #2 Steve Magnusson, Jan 24, 2007
    As a first step, try comparing the starter assy, the ring gear, and the big aluminum part (where the starter mounts) PNs in the SPCs at the Owner's Site and/or the Eurospares Site -- might give you some clues...

    The injected 308/Mondial will have a different starter assy number than the carb 308 (because the solenoid has an additional electrical connection for the fuel system control), but if the big aluminum part is the same, that would be a good sign (and as long as the vendor supplied the "injected" style solenoid, the carb user could just leave that terminal as "unused").
     

Share This Page