328 diff cover | FerrariChat
Buy

328 diff cover

Discussion in 'Technical Q&A' started by rizzo308, Jan 31, 2009.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. rizzo308

    rizzo308 F1 Rookie
    BANNED Silver Subscribed

    Sep 12, 2004
    2,784
    Perth, Australia
    Full Name:
    riggio
    #1 rizzo308, Jan 31, 2009
    is the diff /crown wheel cover able to be removed without removing the cyl head ...............cheers
     
  2. Verell

    Verell F1 Veteran
    Consultant Owner

    May 5, 2001
    7,022
    Groton, MA
    Full Name:
    Verell Boaen
    #2 Verell, Feb 1, 2009
    I've done it on a 308 QV, 328 heads are same casting, so should be doable.

    I removed the muffler, rear headers, fender wells, half-shafts & went at it. IIRC I had to double nut some of the diff cover studs to get them out as my collet type stud puller couldn't get in there. Think I had to back some studs out of the bottom case but leave them loose in the cover as I removed it as there wasn't enough clearance to pull the studs out of the cover. Some of this s/b in this thread:

    http://www.ferrarichat.com/forum/showthread.php?t=43305
     
  3. mk e

    mk e F1 World Champ

    Oct 31, 2003
    13,791
    The twilight zone
    Full Name:
    Help me get this thing finished! https://gofund.me/39def36c
    #3 mk e, Feb 1, 2009
    Would unbolting the rear motor mounts and dropping the trans down a little make it any easier do you think?
     

Share This Page