348 and mondial t cylinder head acorn nut removal tool | FerrariChat
Buy

348 and mondial t cylinder head acorn nut removal tool

Discussion in 'Technical Q&A' started by Peppi, Jul 14, 2006.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Peppi

    Peppi Karting

    Mar 15, 2004
    75
    UK Wales Cardiff
    #1 Peppi, Jul 14, 2006
    I am removing the cylinder head off a Mondial t 1992 , I have purchased a tool from Baum tools FR101 , the tool does not fit the nuts on the inlet side of the cylinder head ,but perfect for the exhaust side of the cylinder head, so can anyone tell me where I could purchase the correct tool for the job , thankyou any replies would be very much appreciated .
     
  2. fmaderi

    fmaderi Formula Junior

    May 8, 2005
    258
    clearwater Fla/NY
    Full Name:
    frank maderi
    #2 fmaderi, Jul 14, 2006
    the socket is difficult to use on the center 3 acorn nuts[[on intake cams] but if you work it you should be able to get it on the acorn.sometimes just lifting the buckets up is all you need . you could also grind the little off that is tight . not uncommon . forza
     

Share This Page