348 - Flywheel & Clutch Fastener Torque | FerrariChat

348 - Flywheel & Clutch Fastener Torque

Discussion in 'Technical Q&A' started by Animate, Apr 1, 2005.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Animate

    Animate Formula Junior

    May 21, 2004
    272
    BC,Canada
    #1 Animate, Apr 1, 2005
    Last edited by a moderator: Sep 7, 2017
  2. vincent355

    vincent355 F1 Veteran
    Rossa Subscribed

    Apr 8, 2003
    6,321
    Wine Country
    Full Name:
    Vincent
    James,

    the manual has the 6 flywheel case bolts @ 24.6 Nm

    Can't seem to find the other ones, but as I don't think they are into an aluminium casing they can be tightned more.
     
  3. Animate

    Animate Formula Junior

    May 21, 2004
    272
    BC,Canada
    Thanks Vincent. BTW, I bought a Torx bit for the flywheel case bolts and the fit is quite poor. Good enough to tighten them but a bit loose for comfort. Are they a variant of the Torx head?
     
  4. vincent355

    vincent355 F1 Veteran
    Rossa Subscribed

    Apr 8, 2003
    6,321
    Wine Country
    Full Name:
    Vincent

    I don't think so. I used standard tools from my set of torx bits and I don't recall a poor fit. Which size bit do you have? I could go in the garage tommorrow and check which sizes I have.
     
  5. Animate

    Animate Formula Junior

    May 21, 2004
    272
    BC,Canada
    I used a T45...
     
  6. vincent355

    vincent355 F1 Veteran
    Rossa Subscribed

    Apr 8, 2003
    6,321
    Wine Country
    Full Name:
    Vincent
    I think I used a t50.
     

Share This Page