(348) For those running 360 wheels

Image Unavailable, Please Login Image Unavailable, Please Login I have 360 modulars on mine with no machining. They look fine to me, you could take a few millimeters off the rear hubs if you’re really anal.

 

I agree. I’ve got the traditional 360 wheels on my 348ss and I didn’t alter them at all. The rears look really really close, like they’re bound to rub the quarters, but they don’t..... believe me, I was super observant when I first installed them, so I inspected them constantly. I think the extra width they give to the rear track looks fantastic on the car. I know it’s only an opinion, but i was never all that fond of the stock 348 wheel style, for me, the 360 wheels really look great on the car!


Sent from my iPhone using Tapatalk

 

360 modulars on the 348 look way better then the standard starfish.

 

I agree.

 

Did nothing except longer bolts for the rears. 95 348 spider

 

The PO of mine had them machined. Too much imho so I've added 11mm spacers up front and 20mm spacers in the rear.

Now the stance is essentially the same as the OEM 348.

I have a before photo but not a similiar after. I'll grab it tomorrow.

I'd say don't machine them. Unless you've really lowered the stance... they shouldn't rub at all.

Sent from my SM-G965U using Tapatalk

 

I've seen a few pictures of F430 wheels on a 348 lately and I really dig the look. I think the parallel double 5 spokes really match the strakes of the car. That being said, everyone says they will not fit and you have to machine them. The wheels have the same offset as the standard 360 wheels so am I missing something? They are 19" instead of 18" but I figure you would just run a lower profile tire. I am worried the brakes will look tiny under 19's, but that can be mended with a big brake kit

 

Did you get a set?? If so, bolt them up and see what happens!

 

I would be wiling to be the guinea pig on these wheels, but it would be cooler if someone else was

 

Ok cool, gotcha. 355 wheels look good but I think they look better without the black two tone on early cars.

I want to add new wheels ASAP but want something different than the 360 starfishes. They look good, but gotta snowflake my car a bit hahaha

 

Image Unavailable, Please Login Image Unavailable, Please Login



I have two sets of 360 modulars so if anyone is in the market.

Please PM if interested.

Cheers, Mat

 

I had 17mm machined off the rear starfish. They sit out further than standard 348 wheels and around the same amount as the later wider version of the stock wheels. 17mm machined off allowed me to use the 35mm wheel bolts from a 308 since the stock for the 360 are 52mm (if I remember correctly).