348 plug wire clips

I'm guessing that they twist out????? Reason I'm guessing is because I busted mine. I thought that they just snapped in, and tried to pop them out, and broke them in the process. NOOOOO I didn't just keep going and breaking them all. LOL. A couple of them were already broken from the previous owner. Anyway, I think that they twist out.

 

lefty loosy 90% of the time they come out clean. 10% the U pulls off the stud and then you need to glue the U back on stud and or remove stud by lefty loosy method

same thing with the very important holders on the cam covers to hold fuel line return. Fires can start by chafing these lines so make sure these U's are doing their holding job.

 

If they break, they are shown here:

4 wire: http://www.ricambiamerica.com/product_info.php?manufacturers_id=&products_id=195455

3 wire: http://www.ricambiamerica.com/product_info.php?manufacturers_id=&products_id=195456

2 wire: http://www.ricambiamerica.com/product_info.php?manufacturers_id=&products_id=195457

 

They'll break

 

By the sounds of them breaking often maybe they should be added to the 30K Service Kit?

http://www.ricambiamerica.com/product_info.php?cPath=40&products_id=162

 

If they break and leave a piece in, do the following.

Get a long thick screw and heat the tip over an oven flame. When red hot, screw into the stuck piece. After a few seconds, the screw will cool down and you just pull it out with the bit.

 

Nice trick Sy. I'll have to give that a whirl.

 

You know, that's a very good idea. There are lots of things I would like to add to the kits but here is the dilemma... it would raise the end customer price a bit, and not everyone wants these things. Here's what I would add (in my mind):

348 kit
Plug Wire Clips
Oil plug
Stabilant
Exhaust donuts
NGK plugs

355 kit
Plug Wire Clips
Oil plug
Stabilant
Exhaust donuts
Hill Engineering Exhaust clamps
NGK plugs

308/328 kits
Spark plug extenders
Plug wire clips
Oil pan/transmission pan gaskets

so forth and so on.


Thoughts? What else would you add?

 

A 5lbs BFH to smash the stupid cat ecu's.

But seriously, some Hondabond or ThreeBond for the gaskets. There is NO need for a Ferrari to leak.

 

I like the plugs, doughnuts and clamps. I already have the clamps though...