What parts do I need besides the ones listed below for the 30 K service (any recomendations as to from where to buy them). Thanks in advance : 1 x RIGHT VALVE COVER GASKET 1 x LEFT VALVE COVER GASKET 4 x CAM SEAL 4 x O-RING 2 x CAM O-RING 8 x SPARK PLUG O-RING 2 x END PLATE GASKET 1 x LEFT PLUG GASKET 1 x RIGHT PLUG GASKET 2 x PLUG WIRE GROMMET 2 x TIMING BELT 2 x TENSIONER BEARINGS 4 x CAM BOLT O-RING 1 x FUEL FILTER 1 x OIL FILTER 2 x AIR FILTER 1 x PS BELT 1 x ALT BELT 1 x AC BELT 2 x WATER HOSE 1 x WATER THERMOSTAT + GASKET
I can't tell you if the list is complete or not but site sponsor Ricambi will and sell you them - also Scuderia or Eurospares in the UK
Add a crank seal Add 8 Spark plugs and mind the fuel rail 'o' rings when dissassembling/reassembly or get spares. ohm out the spark plug wires, be prepared to replace them. (sold idividually if needed) Also drive belt tensioners should be checked/replaced. 'O' rings for A/C system as needed. drain plug crush washers. That's all I can think of at the moment E
While your at it, check the condition of the water pump bearing. If there is ANY movement change it. As for the cooling hoses there are actually more than just two. You will need to change both the hoses that feed the radiator cooling tubes. Then you have the feed and return hoses for the heater. You will also want to change both feed and return hoses on both of the radiators, plus the one that is under the intake plenum, that feeds the cross over pipe. Make sure you get that one changed because it can get over looked.
