Hello I have a 355 M2.7 and havent got the wiring diagram of it. I have the 348 one and on it the crank sensor are on pin 47/48 of the ecu. But 355 must be different because there is nothing on 47. Does somone know it or can you mail me the page of the repair manual please thanks nico Image Unavailable, Please Login
Nico, here are the diagrams I have. Crank sensor is ref 20002, but only 200 can be seen on the diagram. It is definitively connected to the pins 47 and 48. I think the pins you are showing should be 46 and 45, pins 55,54 and 53 being on the LEFT side of the third row on your picture. It is normal that 46 has no terminal... but strange there is nothing in 38 and 39 ????? May be the diagrams are not fully up to date !! Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
hello I understand now that need to be read from right to left and not left to right !! do you have the botton RH of this document, it is the one miss on my CD ? thanks nico
I have 530 ohm on 47/48 and no contact on47/mass 48/mass so I think it is ok and wire are not damaged.
If you look real closely at the "Male" computer side of the connector, you should see tiny numbers on each end. For example a "1" and a "19" at each end of the top row. They are very small numbers. Jay
