355 roof problem | FerrariChat
Buy

355 roof problem

Discussion in '348/355' started by southbill, Dec 11, 2013.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. southbill

    southbill Rookie

    Nov 26, 2013
    4
    #1 southbill, Dec 11, 2013
    forks on power roof not lining up with stub/pin on roof closure. is there anything I can do to adjust?
     
  2. sevminasyan

    sevminasyan Formula 3

    Jun 24, 2008
    1,156
    Glendale, CA
    Full Name:
    Steve
    #2 sevminasyan, Dec 11, 2013
    Your roof is twisting while in operation and that is why its not lining up to my best guestimate. Why its not aligning? left and right are not synchronized. why? May need to bleed the system to release trapped air. Where did it come from? I don't know.

    I hope I am wrong but it could me worst. Bleeding is not a hard task.

    Good luck
    Steve
     
  3. efetchko

    efetchko Rookie

    Mar 11, 2013
    43
    Vancouver, BC
    Full Name:
    Eric B Fetchko
    #3 efetchko, Dec 13, 2013
    I had a similar issue, they replaced the rather pricey potentiometer under the passengers seat ($565 for the part), problem cured. although i could make mine fit by hand., so perhaps you have a bent linkage.
     
  4. southbill

    southbill Rookie

    Nov 26, 2013
    4
    #4 southbill, Dec 24, 2013
    thank all, will try
     
  5. plugzit

    plugzit F1 Veteran
    Silver Subscribed

    Dec 1, 2004
    7,793
    Redondo Beach, CA
    Full Name:
    Bruce Bogart
    #5 plugzit, Dec 24, 2013
    Make sure the elastic in the 2nd bow is pulling the bow UP. Maybe give it a little help.
     

Share This Page