355 SPIDER | FerrariChat
Buy

355 SPIDER

Discussion in '348/355' started by apolloluca, Apr 18, 2010.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. apolloluca

    apolloluca Karting

    Sep 23, 2009
    50
    #1 apolloluca, Apr 18, 2010
    Last edited: Apr 18, 2010
    I took the drivers seat out to have the leather done, when i refitted it i must have put it out of sync as when i operate the roof switch the seats go all the way forward but roof doesn't move, i then have to use emergency switch to finish opening it. Does any one know the reprogramming sequence to reset roof? Thanks in advance.
     
  2. Loser

    Loser Formula Junior

    Apr 11, 2008
    791
    Gilroy, CA
    Full Name:
    Tom
    #2 Loser, Apr 18, 2010
    You need to use the SD2 to calibrate the seat potentiometers. You'll have to take it to the shop for that
     
  3. roadracer311

    roadracer311 Formula 3

    May 6, 2009
    2,398
    San Francisco
    Full Name:
    Paul
    #3 roadracer311, Apr 18, 2010
    I was just thinking about this. I'm using leatherique on my seats right now, and wanted to take them out, but since I have a Spider, I'm afraid I'll cause problems if I pull the seats.
     
  4. apolloluca

    apolloluca Karting

    Sep 23, 2009
    50
    #4 apolloluca, Apr 19, 2010
    I moved the seat along the runners when it was out, I think you would be ok so long as you don't make the same mistake.
     
  5. pourquoi_ne

    pourquoi_ne Karting

    Mar 16, 2006
    224
    England
    Full Name:
    John
    #5 pourquoi_ne, Apr 19, 2010
    Use a car battery and two leads. Connect them to the seat motor - change them round and the seat goes the opposite way. You have to move the runners in order to get at all the bolts that hold them on to the seat. As long as you put the runners back on the seats the exact way they came off you will have no problems. ie dont use any more power to the motor once it is off the seat! Also make sure you get the hex allen drive right into the bolt head. They are tight and if the hex drive slips out you will round off the hex part of the bolt and end up having to drill off the head etc
     

Share This Page