Hello! I have a 2003 360 Spider with the factory Becker unit. I had it at the dealer this week for an alignment and brake pads, and while it was there they had to adjust one of the interior panels just behind the driver's seat where the seat belt fastens as it was coming loose. When I picked the car up today (of course after anyone from service was still there), I noticed that my radio only outputs audio to the subwoofer - no other speakers are working. I am not sure what if any of the work they did could possibly affect this; the only thing I can say is that the radio worked before I dropped it off. I pulled the head unit and checked the harness connection for the speakers as all of the speakers (except subwoofer) are in one connector to the back of the head unit. This connector was seated properly, but I tried reseating it anyway. My guess is that the issue is possibly at the other end of where that harness wire runs to. Any ideas on if there is some crossover potentially located behind the driver? Any ideas in general? Thanks in advance!
I changed the stereos in both my 360's, I'd say the chances of both sides being blown are slim. I know there are balance and fader adjustments on the becker unit, perhaps someone was playing with them at the dealer
No independent crossovers used but you might want to check the fuses for the amp. If that plug is seated intro the radio then it's outputting but it sounds like the amp is not coming on.
Thanks! Will check on that (I had been at the Watkins Glen with the car the last few days so audio was not an issue!)
