I have read most of the discussions on cat ecu, probe, etc. but still need some tech help. 2005 360 Spyder with Tubi. Slow Down Light and Check Eng light are on. The right side probe (Photos) looks defective. Black plastic like material is oozing out of probe. My problem is removing the probe. I removed all the retaining bolts from the right side cover to expose the ECU, but the cover is still stuck in place. Seems to be binding in one spot, near where is goes under the convert top cover. (I already removed the little rubber cushion in this area) Is there a trick to removing this cover, or just use more force? Also, the probe wire is secured to the chassis with a rubber clamp. Can I get to this clamp from under the car, as its impossible (for me) to release it from the top? What would cause this black plastic material to melt (and assume ,ruin the probe? ) Thanks for any suggestions Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
I was getting the following P codes 0301,0303,0304,0302,0300, 1571,0442,0455,0130,1446 Could these all be as a result of a damaged probe? I removed the under car shield, and still do not have good access to the probe wire. Thanks
