360 CH dash problem | FerrariChat

360 CH dash problem

Discussion in 'Challenge/GT Cars/Track' started by jgoughary, Nov 22, 2011.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. jgoughary

    jgoughary Rookie

    Jul 15, 2010
    11
    Texas
    Full Name:
    Jim
    The last time I had my car on track the dash display froze up. I stopped in pit lane to try turning the master switch off thinking it might reset the dash but then my display showed some sort of error message and the tack jumped from 0 to 9000 RPM about once each second. the engine was running normally therefore I assume the problem is dash display only.
    Are dash problems coomon? Any suggestions/information appreciated.
     
  2. goober

    goober F1 World Champ

    Nov 15, 2004
    15,895
    Adelaide & Thredbo
    Full Name:
    Buddy Miles
    I think the dash has its own back up power supply and if the battery loses its power it screws up the dash.
     
  3. jgoughary

    jgoughary Rookie

    Jul 15, 2010
    11
    Texas
    Full Name:
    Jim
    I keep it on a battery tender when not in use therefore I don't think that is the problem.
     
  4. goober

    goober F1 World Champ

    Nov 15, 2004
    15,895
    Adelaide & Thredbo
    Full Name:
    Buddy Miles
    the dash has its own battery supply
     
  5. Bertocchi

    Bertocchi Formula 3
    Consultant

    Jan 28, 2004
    2,325
    Austin, Texas
    Full Name:
    David Castelhano
    Goober is correct both the dash pod and the data acquisition module have an internal battery of their own. The 333SP has a similar system and I had to send several of them to a Marelli specialist to have new batteries installed.
    Tony Whiltshire in Indianapolis was the USA Marelli rep at one point otherwise you may have to look for someone in Europe?
     
  6. jgoughary

    jgoughary Rookie

    Jul 15, 2010
    11
    Texas
    Full Name:
    Jim
    Does anyone have contact information for a USA based Magneti Marelli rep? I'd like to send the system out to have the dash and data acquisition module checked out.
     

Share This Page