360 Electric issues

Just Re shelled a 360 CS.

Engine runs fine.
Lights run fine
Ac Blower not kicking in (Not yet connected the lower dash sensor to it and wonder if its related)
Hazard lights run fine through the alarm but can not turn on by hazard switch or indicators
Wipers do not work . (Bypassed the bonnet open switch )

Checked all fuses and earth connections and everything is fine.

Checked the indicator switch on the steering and nothing obvious there either.

Any tips on relays? Or any test ideas for the wiper and indicators.

Thanks

 

if hazards work with alarm only, but not with blinker stalk, OR hazard button.... most likely it is the blinker relay module. On the 360 it is under the psgr footwell/dash to the right on side wall under the glove box. can't miss the off green color relay with a I belive 7 pin connector. It is bolted to the side wall with an allen head bolt. I bought a swiss solid state replacement relay module and am happy w the results. GL.

 

I agree, I would start with turn signal flasher unit which is located right behind the glove compartment. No need to remove glove compartment, just look up under the dash from the passenger side and the flasher relay is on the right side.

Wipers not working is as you said, usually caused by defective hood microswitch.
Could be caused by other fuses so just kindly go through fuse list and check which ones could trigger the malfunction.
Check fuse A30 - Windscreen wiper.
Check fuse A25 - Windscreen wiper.

Hope that helps.

Dan

 

My wipes stopped work but it was tje wiper motor that went bad on mine.

Sent from my SM-G950U using Tapatalk

 

What does "re shelled" a 360 CS mean? Did I miss a great thread here somewhere?