360 EMBLEM | FerrariChat
Buy

360 EMBLEM

Discussion in 'Technical Q&A' started by livnxs, Oct 26, 2005.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. livnxs

    livnxs Karting

    Mar 27, 2004
    127
    CA
    Full Name:
    Steven
    #1 livnxs, Oct 26, 2005
    On the front hood the emblem is a little loose. I tried to tighten it from the bolt up under and it does not seem to work. Does anyone know how to fix it.

    Also, the driver door does not seem to catch when you open it, does anyone know how to fix that.
    Thank You
     
  2. mike

    mike Formula Junior

    Nov 2, 2003
    721
    Colorado
    Full Name:
    Mike
    #2 mike, Oct 27, 2005
    Remove the emblem, and get some double sided tape from a body shop parts distributor or car moulding distributor..cut/trim the tape to fit and replace it... works great.
    The tape is kinda like a thin foam rubber and it holds! The Ferrari script on my rear bonnet was loose and I noticed the tape had pretty much deteroriated, I cleaned the script, put on new tape and it fixed the problem.

    As fr the door, try adjusting the strike plate, looses the allen screws and with a flshlight, illuminate the area as you close the door and determine if the strike plate needs to be moved up, down, out etc....it may take repeated attempts....
    Otherwise you may have to try and adjust at the hinge...yuk!
     
  3. Diablo

    Diablo Formula Junior

    Jan 6, 2004
    443
    In front of the comp
    #3 Diablo, Oct 27, 2005
    You will have to get someone to remove the inner door panel and fix the cable at the handle end.
     

Share This Page