360 f1 gear change issue | FerrariChat

360 f1 gear change issue

Discussion in 'Technical Q&A' started by robiferretti, Jan 17, 2007.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. robiferretti

    robiferretti F1 Rookie

    Joined:
    Oct 31, 2003
    Messages:
    3,299
    Location:
    NYC area
    Full Name:
    rob ferretti
    clutch was just replaced 2000 miles ago.

    Symptoms:
    -car wont go into reverse.
    -shift from 1-2 has lots of clanking noises coming from rear
    -wont shift higher then 2nd puts into neutral or just clanks in back and stays in 2nd.

    any thoughts?

    clutch position sensor?
    broken linkage?
     
    robiferretti, Jan 17, 2007
    #1
  2. Rifledriver

    Rifledriver Three Time F1 World Champ

    Joined:
    Apr 29, 2004
    Messages:
    37,288
    Location:
    Cowboy Capitol of the World
    Full Name:
    Brian Crall
    If the motor is running it should never go higher than 2 and with it off a fair amount of noise is normal so one of the two of those is OK. No linkage to break. I had for the first time recently a car with a bad clutch position sensor and it had different symptoms.

    Bottom line is it needs to be hooked up to a SD2 checked for errors and do a cycle test and find out.
     
    Rifledriver, Jan 17, 2007
    #2

Share This Page