360 F1 Trans will not engage in AUTO mode | FerrariChat

360 F1 Trans will not engage in AUTO mode

Discussion in 'Technical Q&A' started by JimB1231, Jul 23, 2022.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. JimB1231

    JimB1231 Rookie

    Joined:
    Oct 26, 2021
    Messages:
    1
    Location:
    Norfolk, VA
    Full Name:
    Jim Bennett
    F1 trans shifts fine in manual mode but AUTO mode will not engage. Any clue where to start looking? Actuator? Electrical?
    Thanks
     
    JimB1231, Jul 23, 2022
    #1
  2. flash32

    flash32 F1 Veteran

    Joined:
    Aug 22, 2008
    Messages:
    7,084
    Location:
    Central NJ
    Full Name:
    Dominick
    I would start with a battery reset then check "auto" button console with voltmeter
     
    flash32, Jul 23, 2022
    #2
    Qavion likes this.
  3. Qavion

    Qavion F1 World Champ Silver Subscribed

    Joined:
    Feb 20, 2015
    Messages:
    14,534
    Location:
    Sydney
    Full Name:
    Ian Riddell
    Here's a wiring diagram of the internals of the panel (courtesy of Speedworks FRS).

    Image Unavailable, Please Login

    Basically, check the resistance between pin 3 on the control panel (i.e. which corresponds with the black earth wire... if you can see wire colours on the matching connector) and pin 6 (which corresponds to the pink wire on the car connector).

    Image Unavailable, Please Login

    i.e. Button not pushed = open circuit. Button pushed = closed circuit (0 ohms)

    Full wiring diagram here (Modena):

    https://www.dropbox.com/t/SGbHhBtH2iGqAzPg
     
    Last edited: Jul 24, 2022
    Qavion, Jul 24, 2022
    #3
  4. Qavion

    Qavion F1 World Champ Silver Subscribed

    Joined:
    Feb 20, 2015
    Messages:
    14,534
    Location:
    Sydney
    Full Name:
    Ian Riddell
    Qavion, Jul 24, 2022
    #4

Share This Page