360 f1 | FerrariChat

360 f1

Discussion in 'Technical Q&A' started by pitmanphoto, Aug 9, 2015.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. pitmanphoto

    pitmanphoto Rookie

    Joined:
    Aug 9, 2015
    Messages:
    32
    can anyone help just bought a 04 360 f1 and have not even driven it yet it was delivered to my house and there it sits battery went dead so i charged it now it cranks but still will not start alarm led is always flashing and i can not turn off what the heck happened i have the red fob and that lights up but still does not seem to disable alarm!! thank you!!
     
  2. vrsurgeon

    vrsurgeon F1 World Champ Silver Subscribed

    Joined:
    Dec 13, 2009
    Messages:
    16,543
    Location:
    Charleston, SC
    Full Name:
    Curt
    you may need to press it a few times to get the system to sync up to the cars actually if you haven't make sure that the battery in the remote is a new battery as well sometimes they can go dead if it started before its likely that its just out of sync with the remote try and press it a few times like 10-20 outside the car and see if it locks and then unlocks once it unlocks and then locks you should have 120 seconds to see the internal led a solid color
     
  3. pitmanphoto

    pitmanphoto Rookie

    Joined:
    Aug 9, 2015
    Messages:
    32
    thank you i will give that a shot
     
  4. hessank

    hessank Formula 3 Silver Subscribed

    Joined:
    Aug 8, 2005
    Messages:
    1,929
    Location:
    Canada, Florida
    Full Name:
    Fred
    Were you given the 4 digit PIN Code? If yes use that to at least start it and bypass the use of the fobs until you figure those out. If no, then +1 what Curt suggested. I've had to do both on mine.
     
  5. jomidabr62

    jomidabr62 Rookie

    Joined:
    Nov 23, 2024
    Messages:
    3
    Location:
    Union, IL
    Full Name:
    Michael F. DiGrazia
    I had the same issue a few months ago and it was a weak battery in the remote. Hopefully your issue is this simple. Good luck
     

Share This Page