360 gearbox release bearing tool wanted

Image Unavailable, Please Login

Are you referring to the hand crank hydraulic tool to allow the car to be pushed if stuck in gear with a dead pump?
I have thought about making one, but haven't done it yet. If I need one I am sure I will just make it. However, my plan is to use a master cylinder from a race car and build a small fixture to move the piston with a screw. I made a fixture to push out rusted caliper pistons, so it should be pretty easy. Looking at my fixture, I would just take off the handle and push rod and add a threaded boss that I can screw a rod into. I can take the threaded rod out and put in the handle and push rod.

 

This:
Image Unavailable, Please Login

 

The seal is not broken, the middle one is just made that way. Not a complete circle.
Must be a stick shift that has a pin and slider. If it were an F1, then yes, you would need 95973048 Ricambi Tool.
It looks very dirty in the seals, that can make them leak very easily.

 

$235 for a wrench? Wow. My MIG welder just paid for itself.

 

I've made a couple of those. The bolts are tight and the clearances are small. The first one (Chinese steel) didn't last very long.

 

I made my own from an old craftsman wrench, with a socket I welded to it. Works great. About a 15 dollar investment.

You can also remove the feed lines and go in thought the vent opening in the bell housing.

 

I cannot remember now, was it a 8mm wrench? or 10mm?

 

Case hardening really works!

 

13mm for the 2 pins.