360 N/GT Engine specification | FerrariChat
Buy

360 N/GT Engine specification

Discussion in 'Challenge/GT Cars/Track' started by superflyte, Aug 14, 2018.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. superflyte

    superflyte Karting

    Jun 4, 2009
    101
    Melbourne, VIC
    Full Name:
    Troy
    #1 superflyte, Aug 14, 2018
    I'm trying to gather as much information on the 360 N/GT engine specification as possible. I understand Kessel were involved with the development of the V8.

    Does anyone have info on the following:

    Compression ratio, crank modification, cam specs, intake manifold, exhaust system, rod and piston info, etc.

    Any info would be greatly appreciated. Thanks...
     
  2. Ghostdiver

    Ghostdiver Formula 3

    Mar 18, 2005
    1,348
    Southeast Texas
    Full Name:
    Wally Hollar
    #2 Ghostdiver, Aug 15, 2018
    Bump for your post....looking for this also, specifically the extension piece used on the intake manifold to increase volume I assume. Where this piece be sourced from and what are the benefits of it's use.
     
    superflyte likes this.
  3. NürScud

    NürScud F1 Veteran

    Nov 3, 2012
    7,308
    #3 NürScud, Aug 18, 2018
    Homologation number: NGT 1
    Homologation start: 1/3/2000
    F131, V8 (90o) cyl, 4 stroke, petrol engine, located middle longitudinally 3586.2cc, 85.0 x 79.0 mm

    360 Modena GT
    CR 11.2:1
    430 bhp / 321 KW @ 8500 rpm
    378 Nm / 279 ft lbs @ 5000 rpm

    Aluminium block and head
    Flat plane crankshaft with 5 main bearings
    DOHC, 5 valves / cylinder - 40 valves total
    aspiration: natural with 2 x 30.8mm air restrictors, Magneti Marelli multipoint electronic Fuel injection
    Firing order 1-8-3-6-4-5-2-7
    6 speed Sequential paddle shifted gearbox
    1st: 3.29:1
    2nd: 2.16:1
    3rd: 1.61:1
    4th: 1.27:1
    5th: 1.03:1
    6th: 0.85:1
    final drive 4.44/1, LSD rear differential
     

Share This Page