360 Spider F1 gearbox light on in (N) | FerrariChat
Buy

360 Spider F1 gearbox light on in (N)

Discussion in '360/430' started by browneye, Apr 17, 2011.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. browneye

    browneye Rookie

    Feb 19, 2011
    3
    #1 browneye, Apr 17, 2011
    The gearbox light of my 360 F1 gearbox sometimes starts flickering when in 'N'. Especially with cold engine. It goes out during normal driving. My friend has read out the error codes, but we cannot find the meaning of the F1 gearbox errors, P1741, P1742 and P1775.
    Has anybody any idea where we could find the meaning of these gearbox errors? Could it be the clutch? Gearbox s/w version EAC 19B62, h/w 211023.
     
  2. tazandjan

    tazandjan Three Time F1 World Champ
    Lifetime Rossa Owner

    Jul 19, 2008
    39,197
    Clarksville, Tennessee
    Full Name:
    Terry H Phillips
    #2 tazandjan, Apr 17, 2011
  3. browneye

    browneye Rookie

    Feb 19, 2011
    3
    #3 browneye, Apr 18, 2011
    Thanks Tazandjan. I checked the errorcodes there, but the highest code I can find is P1675. My errorcodes are P1741, P1742, P1775. Is there any other link, where we could find errorcodes higher than P1675?
    Regards, Don
     
  4. kzsport

    kzsport Karting

    Feb 23, 2008
    112
    china
    Full Name:
    BRIAN
    #4 kzsport, Apr 18, 2011
    Hi Don
    I check yr CEL by maserati and detail below this.
    P1741 Torque Converter Clutch Control Error
    P1742 Torque Converter Clutch Solenoid Failed On
    P1775 Transmission System MIL Fault
    Hope these code description could be useful of you.I can't 100% make sure these info the same with ferrari vehicles.so you should take the vehicle to the authentication dealers or specialist maintenance ferrari workshops and diagnosis by SD ..that would be good tobe ture.

    KZ
     
  5. browneye

    browneye Rookie

    Feb 19, 2011
    3
    #5 browneye, Apr 26, 2011
    Thanks KZ. With the F1 Gearbox manual I am going to study and see if I can make something out of these Errors.
    Don
     

Share This Page