Hello all, new guy here - proud owner of 1/2 a Ferrari.... See ..... I have aquired a 360 engine and transmission for a project car I plan to build using this combination. The tranny had some crash damage and was an F1. I converted it over to manual mainly because I did not want to be forced into using all the Ferrari electronics to make the car run. I will be using a Pectel engine management system to drive the engine. Since the CD manual says to ship it back to Ferrari if anything internal needs to be looked at, there isnt much in the way of information on the transmission itself. I patiently made my way through the repairs without the benefit a manual and all work went fine. Until I got to the throw out bearing, ironically this is one thing that is covered by the manual ....except ...... the photo that shows how to remove and possibly what tools are needed are missing from the CD. Can anyone here advise me on what tools work to remove this part from the rather confined space the assembly is in? TIA Rob
You will need a special took, Bill Wann recently did his own clutch change and made a special tool. Here is a link with pic http://www.ferrarichat.com/forum/showthread.php?t=177335&page=4
