3m Clear Bra on 2002 360 Ferrari | FerrariChat
Buy

3m Clear Bra on 2002 360 Ferrari

Discussion in 'Detailing & Showroom' started by NeilA, Nov 14, 2011.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. NeilA

    NeilA Rookie

    Nov 3, 2011
    10
    Louisiana
    Full Name:
    Neil
    #1 NeilA, Nov 14, 2011
    I have a small area (about the size of a quarter) in the bottom edge of my 3m clear bra that is not stuck to the car anymore. It is in the front side of the front tire area on the fender near the ground. It is quite gunky, but I am sure i can clean it. Any advice on how to get this to re-stick and any advice on cleaning the area first?
     
  2. HTP AutoWorks

    HTP AutoWorks Rookie

    Sep 19, 2008
    30
    #2 HTP AutoWorks, Nov 14, 2011
    Once it has lifted and has dirt under it, the film can not be cleaned and layed back down. Unfortunately it will have to be replaced.
     
  3. 1slocrx

    1slocrx Karting

    Jun 26, 2011
    54
    Bay Area, CA
    #3 1slocrx, Dec 3, 2011
    Careful upon removal...if there are any big rock chips that may have gone through the film, when you remove the film the paint will peel off with the film. I had this happen to my 360. Front bumper looks pretty bad now.
     
  4. HTP AutoWorks

    HTP AutoWorks Rookie

    Sep 19, 2008
    30
    #4 HTP AutoWorks, Dec 3, 2011
    Sorry, it will not typically peel off with the film. The only time that will happen is if the film was aplied to fresh paint that has not fully cured. I have removed film off of dozens cars without ever having a paint lifting issue.
     

Share This Page