400i Throttle Linkage | FerrariChat
Buy

400i Throttle Linkage

Discussion in 'Technical Q&A' started by 208 GT4, Jul 1, 2007.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. 208 GT4

    208 GT4 Formula 3

    Dec 27, 2003
    1,769
    Brighton (UK)
    Full Name:
    Dan
    #1 208 GT4, Jul 1, 2007
    I'm trying to remove the inner cam cover of my 400i engine. Ideally I'd like to remove the bar between the red circles in the pic, but at a pinch I could disconnect the joint in the yellow circle. So far I've loosened the clamps on the bar, but I cant see a way of sliding it out. The ends don't appear to have any hexagonal bits to undo?

    Any help greatly appreciated.
     
  2. 208 GT4

    208 GT4 Formula 3

    Dec 27, 2003
    1,769
    Brighton (UK)
    Full Name:
    Dan
    #2 208 GT4, Jul 1, 2007
    Last edited by a moderator: Sep 7, 2017
  3. PAP 348

    PAP 348 Ten Time F1 World Champ
    Lifetime Rossa Owner

    Dec 10, 2005
    100,224
    Mount Isa, Australia
    Full Name:
    Pap
    #3 PAP 348, Jul 2, 2007
    Dan, get a closer picture of what you want to do and maybe some artificial light on it would be good also ;)
     
  4. 208 GT4

    208 GT4 Formula 3

    Dec 27, 2003
    1,769
    Brighton (UK)
    Full Name:
    Dan
    #4 208 GT4, Jul 2, 2007
    Last edited by a moderator: Sep 7, 2017
  5. simonc

    simonc Formula Junior

    Nov 1, 2003
    884
    Herfordshire, UK
    Full Name:
    Simon Campbell
    #5 simonc, Jul 6, 2007
    It's held in place by being a tight fit in the inner race of the bearings in the 'hoops'. Support the hoop somehow - a deep socket wil work - so that you don't snap it off, although it is unlikely, and just drift it out with a drift and a hammer.
     

Share This Page